Removing a load-bearing wall and replacing it with a beam is significantly different from removing interior non-load bearing walls.
Load-bearing walls are structural elements that support the weight of the house. Non-load bearing walls, sometimes called partition walls, do not support loads from above and simply divide spaces. If you’re considering removing a load-bearing wall—whether you plan to do the work yourself or hire a contractor—there are some core issues you must address first.
While a majority of homeowners choose to hire a contractor for this heavy project, in most communities, local building authorities will allow homeowners to do the work. Yet must adhere to the local building code requirements and pass inspections, just like a contractor would. Since all municipalities are different, check with your local permitting authority or building department for guidance.
2. A Building Permit Is Required
Local building construction authorities usually have a hand in all aspects of home remodeling―fences, walkways, decks, ponds, wiring and plumbing upgrades, and structural changes, such as load-bearing wall removal. Most of these projects require a permit and inspections.
It should come as no surprise that your permit agency wants to know if you are taking down a wall that affects the structural integrity of your home. You may even need to submit a detailed plan regarding an alternative support system. Large walls may require an architect’s drawing and/or an engineer’s stamp of approval.
3. Removed Walls Must Be Replaced In Some Way
If you take something out that is structural, it must be replaced. To see how this works on a small scale, consider your home’s windows. Walls are the best way to hold up a house; cutting a hole in the wall can only reduce it’s strength. But window headers―basically small beams―serve to replace the removed portion of the wall framing.
The same principle works for load-bearing walls but on a larger scale. When you or a contractor remove a load-bearing wall, it must be replaced with either:
- Beam only: A horizontal structural beam of sufficient size. Other than the two ends, the beam has no vertical bearing points.
- Beam and post: A horizontal beam that is with one or more intermediate posts between the two end bearing points.
4. The Beam Will Be Below the Ceiling
In most cases, the replacement beam will be lower than the height of the ceiling. This is because the floor structure above rests on top of the beam. Alternatively, to make the beam flush with the ceiling, you have to cut back the floor joists above and set the beam into the plane of the floor, then hang the ends of the joists from the sides of the beam using structural metal joist hangers. This requires considerably more work than simply replacing the load-bearing wall with a beam below the joists.
5. Intermediate Posts Might Make the Project Easier
Intermediate vertical posts (or columns) under a carrying beam admittedly do take away from that flawless open floor plan look. However, any kind of vertical support you can add under a horizontal beam will give your beam assembly far greater strength. Additionally, if you are having issues with the beam protruding too far below ceiling level, posts can allow you to get by with a smaller, and thus less protrusions.
6. Get Help With Beam Sizing
Span tables are readily available but are hard for the layperson to read. In addition, there are several factors to take into account when sizing beams, such as deflection, shear, dead weight vs. live weight, and roof loads. This makes beam sizing difficult for the amateur. A licensed architect, structural engineer or contractor can consult with you on the proper size of the beam. Some licensed professionals may agree to work on a per-hour or per project basis.
7. Temporary support must be used.
Before removing any part of a load-bearing wall’s framing, you must build a temporary support wall on both sides of the load-bearing wall until the foundation floor (usually the basement). This is because the floor joists above may have their ends resting on the load-bearing wall. If you add temporary support on only one side of the wall, the joists on the other side may not be supported.